Pre-fit measure
We attend the cabinet maker's measure-up and add our service requirements to the working drawing.
Service
The plumbing under your kitchen, finished beautifully and inspectable later.
Most kitchen plumbing problems happen because someone ran the supply line behind the cabinet, not through it. We coordinate with your cabinet maker so every joint is accessible, every shut-off labelled, and every appliance properly isolated.
What we plumb in
We work alongside your kitchen designer or appliance installer. If you do not have one we can recommend cabinet makers in Bangsar, Setapak and PJ we have known for years.
- Hot and cold supply to sink & tap, with isolated angle valves
- Three-stage drinking water filtration, dedicated tap
- Dishwasher and washing machine inlet/drain plumbing
- Garbage disposal unit fitment (where building allows)
- Pull-out spray taps, boiling-water taps, hot-only kettle taps
- Grease trap and stack tie-in for shophouse kitchens
Why coordination matters
Three traps we see all the time on poorly-coordinated jobs.
If your kitchen designer wires the cabinets and brings in a plumber as an afterthought, you usually inherit at least one of these.
Hidden joints
Supply elbows tucked behind a fixed back panel so no one can reach them when they weep. We push every joint into the open cabinet face.
No isolation
One shared shut-off for the whole kitchen means a tap drip becomes a full kitchen shutdown. We fit individual angle valves per appliance.
Wrong drain falls
Cabinet-makers sometimes block the natural fall of the waste pipe. We re-grade it before the back panel goes on.
Filter mismatch
A three-stage filter on a tap rated for unfiltered flow rates causes back-pressure failures. We match cartridge to tap, not just brand to brand.
Typical project
Half a day for a like-for-like swap. Three days for a fresh fit.
Rough-in
Stops, isolation valves and stub-outs placed before the carcass goes in.
Second fix
Tap, filter, dishwasher, appliances connected once the worktop is in place.
Test & document
Full leak test, labelled shut-off diagram printed and stuck inside the sink cabinet door.
Common questions
Kitchen-job FAQ.
Do you supply the tap and sink?
We can — we hold supplier accounts with Sin Chew, Rubine and Cleanco — but most clients prefer to choose their own. We are happy to install whatever you bring.
Can you fit a boiling-water tap?
Yes. We install Quooker, Fix and InSinkErator brands. We will warn you if your electrical circuit needs a dedicated breaker first.
What about water filtration?
We are not a water-treatment specialist, but for standard KL municipal supply we install three-stage Cuckoo and Coway under-sink units alongside reputable RO setups.
Refitting a kitchen?
Bring us in at the design stage — saves the headache later.